Vortex pump can be widely used because of its good performance. Firstly, the equipment has low noise and noise when it is running normally. Secondly, when designing the scroll pump equipment, the whole equipment pays more attention to lightweight and miniaturization. Third, the power of the equipment is smaller and more energy-saving. Firstly, under normal conditions, the running noise of the scroll pump is relatively small. Therefore, if abnormal noise occurs during the operation, the equipment is abnormal. At this point, the device needs to be shut down. When it is completely stationary, it should be checked, mainly to see which parts have friction. After finding out the specific reasons, the problem can be solved. In most cases, the lack of lubricating oil between parts may also be a phenomenon of excessive noise caused by parts loosening.
In addition, due to long-term use, combined with the complex working environment on site, foreign bodies may enter the internal of the scroll pump. In view of this situation, we need to remove and restore the equipment after removing foreign bodies. In the field of modern industry, with the continuous improvement of technical level and the increasingly widespread application of air sources, scraper pumps, air compressors, Roots blowers and XGB scroll pumps have been widely used. Among them, XGB scroll pump has its particularity in structure, working principle and performance. Therefore, under certain flow, pressure and specific working conditions, the selection of XGB scroll pump has its advantages. The device belongs to
Its working part is mainly rotating multi-blade impeller and fixed annular passage (shell). Its impeller structure is similar to that of steam turbine impeller, and there are no vulnerable parts. Therefore, one of the highlights of this equipment is its simple structure. The structure design is concise, which not only ensures the stability of the structure, but also facilitates the daily operation and maintenance. Its motor can be directly connected with the XGB scroll pump. All components can be assembled horizontally or vertically. Small size and small area. In addition, its flow and pressure are stable, and there is no unstable pressure range in the operation of the equipment. In fact, there is no mechanical friction between the parts in the equipment and their rotating parts except the bearings at both ends of the spindle and the drive belt.