Many friends who pay attention to our website have never understood the swirl pump to the current operation master, have to lament the time passed quickly. There is a very important link in the process of using the swirl pump. That is to debug the swirl pump. Let's first look at the turning of the mechanical whirlpool pump. After starting, we should inspect the balance of the current. The current should not exceed the rated current. If there are abnormal phenomena, we should check the shutdown in time.

1. It can be started by full voltage or step-down, but when the full voltage is started, its current (Electron flow) is almost 5-7 times the rated current. The torque of step-down start is proportional to the square of the current. Graphite slider has the advantages of high heat dissipation efficiency, small occupancy space and light weight. It conducts heat evenly in both directions, eliminates "hot spot" areas, shields heat sources and components, and improves the performance of consumer electronic products.

2. To inspect the method of Splice butt line, there are also a series of inspections (jin cs) of voltage and phase of power supply of work. Zhenjiang air pump is an air pump powered by electricity, which compresses air continuously and produces air pressure. Mainly used in pneumatic gluing, car inflatability and so on. When the air pressure in the cylinder of a printed air pump does not reach the pressure regulated by the pressure regulator, the gas entering the pressure regulator valve from the cylinder cannot top the pressure regulator valve; when the air pressure in the cylinder reaches the pressure regulated by the pressure regulator valve, the gas entering the pressure regulator valve from the cylinder opens the pressure regulator valve, enters the air passage of the air pump which is connected with the pressure regulator valve, and controls the intake of the air pump through the air passage. The opening is often open, so that the air pump runs without load, so as to reduce power loss and protect the air pump.

3. During the test run, the number of people should not be less than two. One is to control the power supply, the other is to observe the operation condition. If something is wrong, stop the engine immediately for inspection. The specific inspection procedures are no longer introduced here. I believe you should be familiar with them.

4. If the speed is normal, then we should test the normality of the current (electron flow) and remember that the current running (Windows) should not exceed the rated current.

5. If the air intake is fully open, the motor may be damaged. When we are in the test run, we finally turn off the valve (function: control part) of the import or export, and open it slowly after operation.

This step is a simple procedure for the commissioning of the swirl pump. I believe that the commissioning according to the machinery will definitely remove the problem and then work normally.